Tower of Light Systems
Tower of Light Systems feature a proprietary mast guidance system, which provide increased stability during high winds. The manual winch raises and lowers the 6-LED light tower in a controlled manner to any height up to the 32’ maximum elevation point. Installing these oilfield light towers at your site will increase visibility while reducing shadows and accidents. They are highly versatile and durable, so they will work in the harshest conditions and keep providing high visibility for the workers. See the difference that this innovative oilfield lighting system makes.
Dual power, can be plugged in or powered by a diesel generator with an auxiliary fuel tank for up to 36 hours of continuous use
Two C-Mor Tower of Light Systems are equivalent to six typical light towers
When fully lowered, the DOT conforming height allows the unit to be transported on a flatbed trailer.
Two units are equivalent to twelve typical light towers.
Straightforward design to accommodate multiple types of job sites, venues & events.
Environmentally friendly
Slips, Trips, & Falls are DEADLY
According to OSHA, slips, trips, and falls cause 15% of all accidental deaths; second only to motor vehicles.
Increased work site visibility, limiting slips and trips
Fewer work site traffic obstacles, ideal for tight rig sites/locations
Reduced work site noise generation
Reduced road traffic and dust pollution
Safety Advantages
C-MOR
Competitors
Increased work site visibility, limiting slips and trips
Increased work site visibility, limiting slips and trips
Increased work site visibility, limiting slips and trips
Fewer work site traffic obstacles, ideal for tight rig sites/locations
Fewer work site traffic obstacles, ideal for tight rig sites/locations
Fewer work site traffic obstacles, ideal for tight rig sites/locations
Three-point connection with backup 250-pound safety cables to each pole and an additional layer of nut/ bolt security via cotter cables
Three-point connection with backup 250-pound safety cables to each pole and an additional layer of nut/ bolt security via cotter cables
Three-point connection with backup 250-pound safety cables to each pole and an additional layer of nut/ bolt security via cotter cables
Explosion-proof control panel on the ground with on/off switch
Explosion-proof control panel on the ground with on/off switch
Explosion-proof control panel on the ground with on/off switch
Each system, configuration and setup engineer approved and stamped
Each system, configuration and setup engineer approved and stamped
Each system, configuration and setup engineer approved and stamped
Combustion-proof high-efficiency lights
Combustion-proof high-efficiency lights
Combustion-proof high-efficiency lights
The lightest, light system available at under 800 pounds
The lightest, light system available at under 800 pounds
The lightest, light system available at under 800 pounds
No heavy equipment required for rig up or rig down. The lightweight independent pole mounted design allows 2 technicians the ability to complete setup in only a few hours without the use of cranes, or other heavy equipment. Such greatly reduces the risk for accidents during setup
No heavy equipment required for rig up or rig down. The lightweight independent pole mounted design allows 2 technicians the ability to complete setup in only a few hours without the use of cranes, or other heavy equipment. Such greatly reduces the risk for accidents during setup
No heavy equipment required for rig up or rig down. The lightweight independent pole mounted design allows 2 technicians the ability to complete setup in only a few hours without the use of cranes, or other heavy equipment. Such greatly reduces the risk for accidents during setup
Zero spill potential
Zero spill potential
Zero spill potential